What You Will Be Able to Do
By the end of this level you will be able to:
- Work out an energy bill by hand.
- Estimate what one appliance costs to run.
- Explain why a home that uses very little energy can still have a surprisingly large bill.
All you need is your last bill (from Level 1) and a calculator.
Step 1: Understand the Kilowatt-Hour (kWh)
Energy is sold in kilowatt-hours (kWh). A kWh measures energy used. It is not the same as power.
- Watts (W) measure power: how fast an appliance uses energy at a given moment.
- 1 kilowatt (kW) = 1,000 watts.
- 1 kWh is the energy used when something draws 1 kW for 1 hour.
A kWh works like a litre of water. The wattage is how wide the tap is open, and the time is how long you leave it running. The same 1 kWh could be:
- a 1,000 W (1 kW) heater running for 1 hour
- a 2,000 W (2 kW) heater running for 30 minutes
- a 10 W LED bulb running for 100 hours
Gas is billed in kWh too. Your meter measures gas by volume, and your supplier converts that reading to kWh on your bill (you saw this line in Level 1).
Step 2: Learn the Two Charges on Every Fuel
Each fuel (electricity and gas) normally has two charges:
- Unit rate: pence per kWh. The more you use, the more you pay.
- Standing charge: pence per day. You pay it every day you are connected to the supply, even if you use nothing. It helps pay for the networks, meters and supplier running costs.
Do this now: find the unit rate and daily standing charge for each fuel on your bill and write them down.
For reference, Ofgem's price cap averages for customers paying by Direct Debit in England, Scotland and Wales, for 1 October to 31 December 2026, are:
| Fuel | Unit rate | Standing charge |
|---|---|---|
| Electricity | 26.32p per kWh | 54.83p per day |
| Gas | 7.97p per kWh | 29.68p per day |
These prices change every few months and vary by region and payment method. Always use the figures on your own bill. This lesson uses them only as worked examples.
Step 3: Calculate a Bill by Hand
The formula for each fuel is:
Cost = (kWh used × unit rate) + (days × standing charge)
Follow these steps:
- Find the kWh used. Take it from the bill, or subtract the earlier meter reading from the later one (for gas, use the kWh figure the supplier has already converted).
- Multiply kWh by the unit rate. This gives the usage cost.
- Count the days in the billing period, including both the start and end dates.
- Multiply the days by the standing charge. This gives the standing cost.
- Add the two together. Divide pence by 100 to get pounds.
- Repeat for the other fuel, then add both fuels together.
Worked example: 1 October to 31 December (92 days)
Electricity, 650 kWh used:
- Usage: 650 × 26.32p = 17,108p = £171.08
- Standing: 92 × 54.83p = 5,044p = £50.44
- Total: £221.52
Gas, 3,000 kWh used:
- Usage: 3,000 × 7.97p = 23,910p = £239.10
- Standing: 92 × 29.68p = 2,731p = £27.31
- Total: £266.41
Do this now: run the formula on your own bill. If your answer is close to the bill, you have understood it. If it is far off, check for estimated readings, a change in rates partway through the period, or credits and debts carried over.
Step 4: Estimate What an Appliance Uses
Use this formula:
kWh = (watts ÷ 1,000) × hours of use
Then multiply by your electricity unit rate to get the cost.
- Find the wattage on the appliance's rating plate or in its manual.
- Divide by 1,000 to convert it to kW.
- Multiply by the number of hours it runs.
- Multiply by your unit rate.
Examples at 26.32p per kWh:
- 2,000 W electric heater, 3 hours: 2 × 3 = 6 kWh → about £1.58
- 100 W TV, 4 hours: 0.1 × 4 = 0.4 kWh → about 10.5p
- 10 W LED bulb, 5 hours: 0.01 × 5 = 0.05 kWh → about 1.3p
A caution: the wattage on the plate is the maximum. Appliances with a thermostat, such as fridges, ovens and some heaters, switch on and off, so they often use less than this calculation suggests. Treat your answer as an upper estimate.
The lesson here is that high-wattage appliances that make heat (heaters, kettles, tumble dryers, ovens) cost far more per hour than lights or electronics.
Step 5: See Why Low Users Feel the Standing Charge Most
The standing charge is fixed, so it does not shrink when you use less. Compare two homes over a year using the example electricity rates (365 × 54.83p = £200.13 in standing charges for both):
| Home | kWh per year | Usage cost | Standing cost | Total | Standing share |
|---|---|---|---|---|---|
| Small flat | 1,200 | £315.84 | £200.13 | £515.97 | about 39% |
| Larger home | 2,700 | £710.64 | £200.13 | £910.77 | about 22% |
The flat uses less than half the electricity, but its bill is not halved. Nearly two-fifths of what it pays is fixed. This means:
- Cutting your kWh lowers only the usage part of the bill.
- In a low-use home, the standing charge can be a large share of the total.
- Turning appliances off saves money, but it can never take your bill to zero.
Key Takeaways
- A kWh is 1 kW of power used for 1 hour. It is the unit that energy is sold in.
- Bill = (kWh × unit rate) + (days × standing charge), worked out for each fuel.
- Appliance kWh = (watts ÷ 1,000) × hours. Multiply by the unit rate to get the cost.
- Appliances that make heat use the most energy per hour.
- The standing charge is paid daily whatever you use, so it takes up a bigger share of the bill in low-use homes.
- Prices change. Always use the rates printed on your own bill.