Why Tyres Matter
Your tyres are the only part of the car that touches the road. Each one grips through a contact patch about the size of your hand. Everything you ask the car to do (steer, brake, accelerate) goes through those four small patches.
Tyres affect three things:
- Safety: worn or under-inflated tyres grip less, especially in the wet, so the car takes longer to stop.
- The law: driving on illegal tyres can bring a fine of up to £2,500 and 3 penalty points for each illegal tyre. Four bad tyres could mean 12 points and a driving ban.
- Cost: tyres at the wrong pressure wear out faster and need replacing sooner.
The Highway Code says you should check tyre pressures weekly. This level covers three checks: tread depth, pressures and condition.
Task 1: Measure Your Tread Depth
Tread is the pattern of grooves cut into the tyre surface. The grooves move water out from under the tyre so the rubber can keep hold of the road.
The legal minimum for cars: at least 1.6mm of tread across the central three-quarters of the tyre's width, all the way round the tyre.
That means a tyre with good tread at the edges and a bald strip in the middle is still illegal. So is a tyre that is fine in most places but worn down in one patch.
Option A: Use a tread depth gauge
A tread depth gauge is cheap and sold at motor shops and fuel stations.
- Push the pin of the gauge right into one of the main grooves.
- Press the body of the gauge flat against the tread.
- Read the depth in millimetres.
- Repeat at the centre and both sides of the tyre, and at several points around it. Roll the car forward a short way to reach the next part.
- Write down the lowest reading for each tyre.
Option B: The 20p test
If you have no gauge, a 20p coin gives a quick first check.
- Put a 20p coin into one of the main tread grooves.
- Look at the coin's outer band (the raised rim around the edge).
- Outer band hidden: the tread is above the legal limit at that point.
- Outer band visible: the tyre may be illegal or unsafe. Have it checked by a tyre professional straight away.
- Repeat at several points across and around every tyre.
DO: Treat the 20p test as an early warning, not an exact measurement. If a result is borderline, use a gauge or go to a tyre fitter.
Task 2: Check and Adjust Tyre Pressures
Pressure is how much air is in the tyre, measured in PSI or bar. If the pressure is too low, the tyre sags, the edges wear and the steering feels heavy. If it is too high, the tyre balloons, wears in the centre and grips less.
Step 1: Find the correct figures
In Level 1 you found your car's handbook. Look up the tyre pressures in it. The same figures are usually printed on a sticker on the driver's door frame or inside the fuel filler flap.
You will often see:
- separate figures for front and rear tyres
- a higher figure for a fully loaded car (passengers plus luggage)
The Highway Code says tyres must be inflated to the manufacturer's figure for the load being carried. Before a loaded holiday trip, use the full-load figure.
DON'T use the number moulded into the tyre's sidewall. That is the tyre's maximum pressure, not the figure for your car.
Step 2: Check when the tyres are cold
Driving warms the tyres, and warm air reads higher. Check before a journey, or leave the car parked for about an hour first.
Step 3: Measure and adjust
- Take the dust cap off the tyre valve and keep it safe.
- Press a reliable pressure gauge (or the air line's connector) firmly onto the valve until the hissing stops.
- Read the pressure.
- If it is low, add air in short bursts and check again.
- If it is high, press the small pin in the centre of the valve to let some air out, then check again.
- Put the dust cap back on.
- Repeat for all four tyres. If your car has a spare, check that as well.
DO: If one tyre keeps losing pressure from week to week, have it checked for a slow puncture.
Task 3: Inspect the Tyre's Condition
Walk round the car in good light. Turn the steering wheel fully to one side so you can see more of the front tyres. Look for the following:
- Cuts: slits in the tread or sidewall, especially deep ones.
- Bulges or lumps: usually on the sidewall. A bulge means the tyre's internal structure is damaged and the tyre could fail suddenly.
- Cracking: fine cracks in the rubber, common on old tyres or ones that have stood unused for a long time.
- Objects stuck in the tread: nails, screws or glass.
- Uneven wear:
- both outer edges worn: often a sign of under-inflation
- centre worn: often a sign of over-inflation
- one edge worn: may point to a wheel alignment or suspension fault
What to do if you find a problem
- Bulge, deep cut or exposed cord: do not drive on it. Fit the spare if you have one, or arrange help, and get a professional to inspect the tyre.
- Nail or screw in the tread: do not pull it out, because it may be sealing the hole. Take the car to a tyre fitter soon.
- Cracking or uneven wear: book a tyre fitter or garage to look at it. Uneven wear also means the cause needs fixing, not just the tyre.
The Highway Code says tyres must be free from certain cuts and other defects. If you are unsure, ask a professional.
Key Takeaways
- The legal minimum tread for cars is 1.6mm across the central three-quarters of the tyre, all the way round.
- Illegal tyres can cost up to £2,500 and 3 points per tyre.
- In the 20p test, if you can see the coin's outer band, get the tyre checked.
- Check pressures weekly, with the tyres cold, using the figures in the handbook or on the door or fuel-flap sticker, not the sidewall maximum.
- If a tyre has a bulge or deep cut, stop using it and get a professional to inspect it.